Sunday 22 July 2012

How To Prevent Condensation Damage In Your Aluminium Door

How To Prevent Condensation Damage In Your Aluminium Door

Unfortunately, the threshold of aluminium doors is known to retain moisture
and condensation, which can cause all sorts of problems (including rust
formation and mould growth). Over time, these problems can spread into the
floor surrounding the door, resulting in some costly repairs. To prevent
this sort of damage in your home, you should replace your current aluminium
threshold with a new thermal one.

Step 1: Remove the old threshold for your aluminium door by unscrewing it
(the screws are usually found underneath the weather stripping that sits on
top of the threshold).

Step 2: Carefully look over the wooden doorframe beneath to see whether any
damage has already been caused. If rust or mould is present, you will need
to call in a professional to repair this damage before continuing.

Step 3: Take some threshold tape and cut it to the correct length, adding
an extra 2 inches so that you can have 1 inch leeway either side of your
doorway. Peel off the tape's protective backing and press it into the
doorsill. Trim away the excess tape when you're happy.

Step 4: Install the new thermal threshold by screwing it into place where
the old one was. Make sure that it is angled away from your house so that
water and moisture will simply run off. To finish, apply a bead of silicone
caulk to the threshold where it meets the doorjamb.

The wooden frame beneath your aluminium door should now be protected
against the dangers that water and moisture poses. At the same time as
checking the frame for problems (step 2), you should also inspect the floor
either side of the door, especially if you find signs of damage.

http://www.nulinewindows.com.au/blog/aluminium-doors/how-to-prevent-condensation-damage-in-your-aluminium-door/

If you have any questions or comments please contact me.

Regards Gerald

Website: http://www.webcraft.ws
E-mail: gerald@webcraft.ws
Twitter: WebcraftGuru
Facebook: Webcraft Guru


I'm protected by SpamBrave
http://www.spambrave.com/

No comments:

Post a Comment